ZyXEL Communications MWR211 - V1.0 Manual page 64

Key 1 to Key The WEP keys are used to encrypt data. Both the MWR211 and the
4 wireless stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10
hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any
one time. The default key is key 1.
Apply Click Apply to save your changes back to the MWR211.
Reset Click Reset to reload the previous configuration for this screen.
7.5.3 WPA(2)-Personal/Enterprise
Use this screen if the access point to which you want to connect uses WPA(2)-
Personal/Enterprise security mode.
Figure 43 WPA-PSK/WPA2Personal/Enterprise (WISP)
The following table describes the labels in this screen. .
Table 27 WPA-PSK/WPA2-PSK (WISP)
LABEL DESCRIPTION
Wireless Setup
MWR211 User's Guide
64