Igmp Snooping Screen - ZyXEL Communications MWR211 - V1.0 Manual

Enable Auto-bridge
mode
Apply
Reset

10.7 IGMP Snooping Screen

Use this screen to enable IGMP snooping if you have LAN users that subscribe to
multicast services.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group - it is not used to carry user data.
Click Network > WAN > IGMP Snooping. The screen appears as shown.
Figure 77 Network > WAN > IGMP Snooping
The following table describes the labels in this screen.
Table 48 Network > WAN > IGMP Snooping
LABEL
Auto-bridge
Enable IGMP
Snooping
Apply
MWR211 User's Guide
Select this option to have the MWR211 switch to bridge mode
automatically when the MWR211 gets a WAN IP address in the
range of 192.168.x.y (where x and y are from zero to nine) no
matter what the LAN IP address is.
Click Apply to save your changes back to the MWR211.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select this option to have the MWR211 use IGMP snooping.
Check the LAN port to which IGMP snooping applies.
Click Apply to save your changes back to the MWR211.
124