Advanced Wan Screen - ZyXEL Communications MWR211 - V1.0 Manual

Connect
Reset

10.6 Advanced WAN Screen

Use this screen to enable Multicast and enable Auto-bridge.
Note: The categories shown in this screen are independent of each other.
To change your MWR211's advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Figure 76 Network > WAN > Advanced
The following table describes the labels in this screen.
Table 47 Network > WAN > Advanced
LABEL
Multicast Setup
Multicast
Auto-bridge
MWR211 User's Guide
Click Connect to save your changes back to the MWR211. If a 3G
adapter is inserted in the USB port, MWR211 will start connection.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select IGMPv1/v2 to enable multicasting. This applies to traffic
routed from the WAN to the LAN.
Select None to disable this feature. This may cause incoming
traffic to be dropped or sent to all connected network devices.
123