ZyXEL Communications MWR211 - V1.0 Manual page 121

Pin Code
Enable Data Usage
Counter
Data Usage
Limit (Mb)
Reset Data
Usage Counter
on
Reset Data
Usage Counter
Tear Down
Connection
when over Limit
Failover Configuration
Enable Fallback
Check Period
Check Timeout
Check Tolerance
Check Connectivity
MWR211 User's Guide
Type the Pin Code given to you by your mobile broadband
provider.
Select this option to enable the Data Usage Counter settings.
The data usage counter is for user convenience. It is not
synchronized with the Carrier's actual data usage.
Enter the desired data usage limit in megabytes.
Example: 5 gigabytes equals 5000 megabytes.
Select the day of the month for the Data Usage Counter Reset to
the default value.
Select the value in megabytes for the Data Usage Counter to begin
counting from.
Example: You have 100Mb of data usage available but you do not
want to allow the entire 100Mb to be used. You can set the Reset
Data Usage Counter to 60Mb and the Data Usage Counter will start
at 60Mb. When the Data Usage Limit reaches 100Mb, you will still
have 40Mb left from the total 100Mb. This will allow you to be
notified when close to your Data Usage Limit and not when it has
been fully emptied.
Select this option to automatically disconnect your mobile
broadband connection when you reach your Data Usage limit.
Select this option to have the MWR211 return to wired WAN if it is
available.
The interval to wait when monitoring the wired WAN and mobile
WAN connections.
The shorter the time period, the faster the MWR will react to an
interruption in one of the WAN connections, but the more network
bandwidth is used (if connectivity check enabled) and the more
system resources are used.
If connectivity check is enabled, how long to wait for a reply from a
remote host before counting it as a failure.
If connectivity check is enabled, how many consecutive failures are
needed before the connection is considered broken.
Select this option to have the MWR211 ping a remote host to
121