Internet Access - ZyXEL Communications MWR211 - V1.0 Manual

31.3

Internet Access

I cannot access the Internet.
Check the hardware connections, and make sure the LEDs are
1
behaving as expected. See the Quick Start Guide.
Make sure you entered your ISP account information correctly. These
2
fields are case-sensitive, so make sure [Caps Lock] is not on.
If you are trying to access the Internet wirelessly, make sure the
3
wireless settings in the wireless client are the same as the settings in
the AP.
• Go to Network > Wireless LAN > General > WDS and check if the
MWR211 is set to bridge mode. Select Disable and try to connect to
the Internet again.
Disconnect all the cables from your device, and follow the directions in
4
the Quick Start Guide again.
Go to Maintenance > Sys OP Mode > General. Check your System
5
Operation Mode setting.
• Select Router if your device routes traffic between a local network
and another network such as the Internet.
• Select Access Point if your device bridges traffic between clients on
the same network.
If the problem continues, contact your ISP.
6
I cannot access the Internet though mobile WAN
1. Make sure your 3G adapter is activated, account is valid with your
Internet service provider
2. Make sure you have configured the mobile WAN port correctly.
3. Disconnect the 3G adapter from the USB port, and follow the directions
in the Quick Start Guide again.
5. Make sure you have selected router mode under Sys OP mode
configuration page.
I cannot access the Internet anymore. I had access to the Internet (with
the MWR211), but my Internet connection is not available anymore.
Check the hardware connections, and make sure the LEDs are
1
behaving as expected. See the Quick Start Guide and
Reboot the MWR211.
2
MWR211 User's Guide
209
Section 1.5.