Where To Put Your Copier - Ricoh FW770 Operating Instructions Manual

WHERE TO PUT YOUR COPIER

Your copier needs to be installed by a qualified technician. If you need
to transport your copier to a distant location, call your service center be-
fore the move.
You can of course move your copier around your office without calling
the service center. If you do, remember that the temperature, humidity,
and cleanliness of the area around the copier may affect its perform-
ance. Choose the new location with care and follow the guidelines below.
Optimal environment
F
Temperature: 15° to 30° C (59° to 86° F)
F
Humidity: 20 to 80 % RH
F
To avoid possible ozone build-up make sure to install this copier
in a large well ventilated room ensuring an air turnover of at
least 30 m
F
Set your copier on a strong and level base. The copier must be
level within less than 5 mm (1/4") left to right and less than
10 mm (1/2") front to rear.
Environments to avoid
F
Locations exposed to direct sunlight or strong light (more than
1500 lux);
F
Dusty areas;
F
Areas with corrosive gases present;
F
Altitudes of over 2000 m (6500 ft) above sea level;
F
Areas prone to strong vibrations;
F
Locations directly exposed to cool air from an air conditioner or
heat from a nearby heater. (Sudden temperature changes may
lead to condensation within the copier.)
42
3 /hour/person (1000 ft 3 ).