Ricoh FW770 Operating Instructions Manual page 46

The Outside Of The Copier
Ref. What it is
Locks
1, 1a
Front cover
2
Original table
3
Holder for the
4
operating
instructions
5
Copy exit guide
6
Operation panel
Rear table
7
8
Roll feeder (option)
Guides (option)
9, 9a
Copy table
10
11
Original exit
Roll feeder covers
12
13
Copier table (option)
14
Main switch
WHERE IS IT & WHAT IS IT
What it does
Squeeze both locks to open the unit. Open the unit to
empty the used toner bottle and to remove jammed paper.
Open this cover (and the unit) to access the toner
cartridge.
Place your original here, face up. If you want to copy a
stiff original that can't be bent, use the rear table (see 7).
Place this booklet here when you're not reading it.*
Makes sure the copies don't fall off as they come out.
See page 38.
1) Place stiff originals here, face down.
2) Open to remove jammed paper from fusing unit.
Feeds paper from a roll to the copier.
Use the guides to keep the original and copy paper going
straight as you feed them into the copier.
Open this table if you are copying to sheets, changing the
toner cartridge, or if you have to open the unit.
The original will come out from here after it is copied.
Open these covers to change the roll of paper and to clear
paper jams.
Holds your copier and roll feeder.
Turn on to start the copier and off when you're done for
the day. The copier will need about 5 minutes to warm up
if it's been turned off for a long time.
*Please!
41