Ricoh FW770 Operating Instructions Manual page 20

Programming Settings You Often Use
C/
2–Changing The Copier's Default Settings
You might find that you never use the copier's default settings, that you
always set a lead margin of 10 or 20 mm, or that you always use the roll
feeder with a particular length of paper.
In this case, you might want to change the settings that appear when
you turn on the copier or press the Clear Modes key
low the steps below.
4. To retrieve the programmed set-
tings, press the Program key be-
fore copying.
1. Turn the main switch off.
2. Press and hold the Emergency
Stop key, then turn the copier
back on. The jam and service in-
dicators blink.
COPYING
. To do so, fol-
15