Ricoh FW770 Operating Instructions Manual page 17

COPYING Using The Rear Table—Originals That Can't Be Bent
Using The Rear Table—Originals That Can't Be Bent
You can feed originals from the rear of the copier. This way, the original
will not turn inside the machine, but will travel straight through. Use the
rear table to copy originals that can't or shouldn't be bent.
Do not insert originals thicker than 3mm (about 1/8").
12
1. Lower the exit copy guide.
2. Remove the exit copy holder.
3. Proceed as for a usual copy with
or without the roll feeder. How-
ever, do not set the original on
the original table. See step 4.
4. When the Set Original indica-
tor lights up on the operation
panel, insert the original face
down.
5. If your original is longer than
800 mm (31", larger than A0)
hold it up as the copier takes it in.