Ricoh FW770 Operating Instructions Manual page 44

Displays and Keys
Ref. What it is
Set Paper
and
RF Select
6
indicators
Wait indicator
Clear Modes/Stand-by
7
key
8
Program key
Function Select key
9
Paper Length
indicator & Copy
10
Counter
11
Preset Cut key
12
RF Select key
Copy Media key
Vellum
13
and Film
indicators
Emergency Stop
14
Density indicator
15
Darker key
Lighter key
Clear Stop key
16
WHERE IS IT & WHAT IS IT
What it does
These usually light up together. They light when you can
set paper on the table or select and start the roll feeder. If
you don't have the roll feeder option, the RF Select
indicator will not light.
Shows that the copier is not yet ready to copy.
Returns the copier to the default settings. Press and hold
3 sec. to let the fusing unit cool down. This saves energy,
but increases the waiting time at the next copy job.
Allows you to recall or set a program.
Lets you switch your input from, the lead margin, the copy
counter, or the paper length. (See 1.) Also used for
copying a selected portion of the original.
1) Shows the length of paper the roll feeder will send.
2) Shows the number of copies to make.
3) Displays FULL when the used toner bottle needs to be
emptied.
Scrolls through the preset paper lengths for the roll feeder.
Selects the roll feeder as the source of copy paper.
Tells the copier what kind of copy paper you are using.
The copier will apply more or less heat accordingly.
Shows when vellum is the selected copy media.
Shows when film is the selected copy media.
When both indicators are off, the copier is set for plain
copier paper.
Pressing this key will stop the copying process immedi-
ately. Use if your original is getting stuck in the copier.
Shows the density level the copies will have.
The Darker key will increase the density.
The Lighter key will decrease the density.
Tells the copier to stop copying and clear the copier. (The
copier will finish the copy, feed out the original, and stop.)
39