Using The Bypass Tray - Muratec MFX-2500 Operating Instructions Manual

Getting started

Using the bypass tray

Note: The optional single sheet bypass tray is required.
If you want to copy onto the transparency film, thick paper, envelopes or post cards,
use the bypass tray.
Note: Also, your machine's multi-purpose cassette (1st cassette) can hold these
papers.
Note: You can set the paper in the bypass tray with a length of 3.6 to 11.7 (91 to
297 mm) and width of 5.5 to 17 (140 to 432 mm).
Important: If loading transparency (OHP) film, be sure that the film does not
have a paper backing and/or a leading strip. If it does, remove the
paper backing and/or strip before inserting.
1
Open the bypass tray.
2
Place a sheet of paper on the bypass tray.
Then align the paper guides to the sheet's
edges and insert the sheet until it comes
to a stop.
• If you are going to make more than
one copy, you should insert the paper
only one page at a time.
3
Press [Ppr.Size] to enter the paper size.
When using the standard paper size:
(1) Select the paper size using the cursor key.
(2) Press [Enter].
1.10
When using the non standard paper size:
(1) Press [Other].
(2) Select the paper size using the cursor key.
(3) Press [Enter].
When using the special sized paper:
(1) Press [Other].
(2) Select "Custom" using the cursor key.
(3) Press [Enter].
(4) Enter the horizontal and vertical size of the
paper using the numeric keypad.
Note: You can also enter the paper size
using and of the cursor key.
Note: To change Horizontal/Vertical, use
and of the cursor key.
(5) Press [Enter].
4
Next, you should select the paper type.
Note: If you using the standard type of paper (plain paper), you can skip
this step. Otherwise, proceed as follows.
(1) Press [Ppr.Size].
(2) Press [Ppr.Type].
(3) Select the paper type using the cursor key.
(4) Press [Enter].
(5) Press .
RESET
5
Either insert the document in the ADF or place it on the FBS.
Note: Place the original document in the same orientation as the paper in
the bypass tray.
6
Press to begin the copying process.
START