How To Set The Document; Acceptable Document Size; Auto Document Size Detection - Muratec MFX-2500 Operating Instructions Manual

Getting started

How to set the document

Acceptable document size

The acceptable dimensions as follows:
Automatic document feeder (
S -
INGLE SHEET
Maximum: 11.8 35.4 (Tx)
11.8 17.7 (Copy)
Minimum: 4.7 3.9
Weight: 30.2 – 104.7 g/m
You can set up to about 50 sheets of letter-, 40 sheets of legal- or 30 sheets of
11 17 sized document in the ADF at a time.
Flatbed scanner ( ) glass (width length)
FBS
Maximum: 11.0 17.0
Things not to put in your machine
To avoid paper jams and damage to your machine, don't insert:
• Folded, curled, torn, wrinkled or very thin pages
• Documents with staples, glue, tape, paper clips or still-wet correction fluid
• "Sticky notes" (or documents with "sticky notes" attached)
• Cardboard, newspaper or fabric
• Pages with duplicating carbon on either side
• Credit cards or any small, thick items
1.18
) (width length)
ADF
M -
ULTIPLE SHEET
11.0 17.0
8.5 5.5
52.3 – 104.7 g/m
2 2
How to set the document
When set the documents in the Automatic Document Feeder
1
Set your document face up into the docu-
ment feeder. The document should be
aligned to the rear left corner.
2
Adjust the document guide to fit your docu-
ments.
Note: You cannot set the different sized docu-
ment at a time.
When set the documents on the FBS glass
1
Lift the platen cover fully.
2
Set your document face down
on the glass. The document
FBS
should be aligned to the rear
left corner.
3
Gently close the platen cover.
Note: If you do not lift the platen
cover fully, the document size
will not be detected automatically.

Auto document size detection

The following sized documents are automatically detected.
• Letter(8.5 11 )
• Legal(8.5 14 )
• Ledger(11 17 )
• Half-letter(5.5 8.5 )