Muratec MFX-2500 Operating Instructions Manual page 94

Default copy settings
01. Copy scan setting
Note: Default: Document type is set to "Auto", Image density is set to "Auto".
You can change the priority mode of Document type and Image density.
1
Press , [Copy Set].
MENU
2
Select "E. User Settings" and then press
[Enter].
3
Select "01. Copy Scan Setting" and then
press [Enter].
4
If you want to change the priority mode of
document type, select "Doc. type" and then
press [Enter].
5
Select desired mode and then press [Enter]
to save the setting.
6
If you want to change the priority mode of
image density, select "Contrast" and then
press [Enter].
7
Select desired mode using the cursor key, and
then press [Enter] to save the setting.
8
Press [Exit] or to save the default set-
RESET
ting.
Note: Press to return to standby.
RESET
3.4
02. Width of the separator line
Note: Default: 0.01 inch
You can change the width of the separator line in the Combine and Repeat function.
The default setting is 0.01 inch, but you can change it to within 0.01 – 0.05 inch in
0.01 inch steps.
1
Press , [Copy Set].
MENU
2
Select "E. User Settings" and then press [Enter].
3
Select "02. Separator Line Width" and then press [Enter].
4
Enter the width of the separator line you
want to set to default.
5
Press [Enter] to save the setting.
6
Press to return to standby.
RESET