Some Guidelines; Acceptable Document Size; Things Not To Put In Your Fax; How To Set The Document - Muratec MFX-2500 Operating Instructions Manual

Some guidelines

Acceptable document size

The acceptable dimensions as follows:
•In the Automatic Document Feeder(ADF)
Feed direction
Automatic document feeder (
ADF
S -
INGLE SHEET
300 mm × 900 mm
Maximum:
120 mm × 100 mm
Minimum:
Weight: 30.2 – 104.7 g/m 2
You can set up to about 50 sheets of A4-, 40 sheets of B4- or 30 sheets of A3-sized
document in the ADF at a time.
) glass (width × length)
Flatbed scanner (
FBS
297 mm × 420 mm
Maximum:

Things not to put in your fax

To avoid paper jams and damage to your machine, don't insert:
• Folded, curled, torn, wrinkled or very thin pages
• Documents with staples, glue, tape, paper clips or still-wet correction fluid
• "Sticky notes" (or documents with "sticky notes" attached)
• Cardboard, newspaper or fabric
• Pages with duplicating carbon on either side
• Credit cards or any small, thick items
•On the Flatbed Scanner(FBS) glass
) (width × length)
M -
ULTIPLE SHEET
297 mm × 420 mm
148 mm × 105 mm
52.3 – 104.7 g/m 2

How to set the document

When setting the documents in the Automatic Document Feeder
1
Align your document to the rear left corner.
2
Adjust the document guide to fit your docu-
ments.
3
Set your document face up into the docu-
ment feeder.
Note: You cannot set the different sized docu-
ment at a time.
When setting the documents on the FBS glass
1
Lift the platen cover fully.
2
Set your document face down
on the glass. The document
FBS
should be aligned to the rear
left corner.
3
Gently close the platen cover.
Note: If you do not lift the platen
cover fully before close it, the
document size will not be detected automatically.

Auto document size detection

The following sized documents are automatically detected.
• A3
• B4
• A4
• B5
• A5
Getting started
1.5