Welding Programs - Kemppi X5 FastMig Operating Manual

For the X5 Wire Feeder HD300 part descriptions, refer to "X5 Wire Feeder HD300" on page 22 and "Wire feed mech-
anism" on page 20.
For the control panel descriptions, refer to "AP/APC control panel" on page 26 and "Manual control panel" on page 26.
X5 cooling units:
• X5 Cooler, 1 kW
• X5 Cooler MV, 1 kW, multi-voltage.
For the cooling unit part descriptions, refer to "X5 cooling unit (optional)" on page 31.
MIG welding guns:
• Flexlite GX welding guns.
For more information on the Flexlite GX welding guns, refer to

Welding programs:

Welding programs and Wise features are supported by the automatic, 1-MIG-enabled wire feeders. WiseRoot+,
WiseThin+ and MAX Position processes require a pulse welding system. With the Wise processes, specifically a Pulse+
power source is required.
Except for WiseSteel and WiseFusion, MAX and Wise software features are extra cost performance options (optional
extras).
• Welding program work pack (factory installed by default)
• 1-MIG Wise features: WiseSteel and WiseFusion (with welding program work pack)
• 1-MIG Wise features: WisePenetration (optional extra)
• Additional 1-MIG welding programs (optional extras)
• Additional advanced welding processes: WiseThin+, WiseRoot+, MAX Cool, MAX Speed and MAX Position (optional
extras).
For more information on acquiring additional welding programs and optional welding processes, contact your local
Kemppi dealer.
Subfeeders:
Subfeeder support is available with all new X5 Wire Feeder 300 models.
• SuperSnake GTX subfeeder.
For more information on the SuperSnake GTX subfeeder, refer to
For more information on optional accessories, refer to "Optional accessories" on page 32 or contact your local Kemppi
dealer.
© Kemppi
Kemppi Userdoc.
Kemppi Userdoc.
9
X5 FastMig
Operating manual - EN
1920960 / 2440