Important Notes - Kemppi X5 FastMig Operating Manual

Table. X5 FastMig minimum configuration requirements for each system (Manual/Auto/Pulse):
Wire Feeder:
Power Source:
1)
X5 FastMig Manual equipment is meant for welding with manual controls.
2)
X5 FastMig Auto equipment allows also automatic 1-MIG welding featuring additional welding processes as optional.
3)
X5 FastMig Pulse equipment allows also automatic 1-MIG and pulse welding featuring additional welding processes as
optional.
For more information on the individual X5 FastMig devices, refer to the "Equipment description" on the next page
chapter.

Important notes

Read the instructions through carefully. For your own safety, and that of your working environment, pay particular atten-
tion to the safety instructions delivered with the equipment.
Items in the manual that require particular attention in order to minimize damage and harm are indicated with the
below symbols. Read these sections carefully and follow their instructions.
Note: Gives the user a useful piece of information.
Caution: Describes a situation that may result in damage to the equipment or system.
Warning: Describes a potentially dangerous situation. If not avoided, it will result in personal damage or fatal injury.
Kemppi symbols: Userdoc.
General notices: Userdoc.
DISCLAIMER
While every effort has been made to ensure that the information contained in this guide is accurate and com-
plete, no liability can be accepted for any errors or omissions. Kemppi reserves the right to change the spe-
cification of the product described at any time without prior notice. Do not copy, record, reproduce or transmit
the contents of this guide without prior permission from Kemppi.
© Kemppi
(1
X5 FastMig Manual
X5 Wire Feeder 200 Manual
X5 Wire Feeder 300 Manual
X5 Wire Feeder HD300 M
X5 Power Source 400
X5 Power Source 500
X5 Power Source 400 MV
(2
X5 FastMig Auto
X5 Wire Feeder 300 AP
X5 Wire Feeder 300 APC
X5 Wire Feeder HD300 AP
X5 Wire Feeder HD300 APC
X5 Power Source 400
X5 Power Source 500
X5 Power Source 400 MV
6
Operating manual - EN
(3
X5 FastMig Pulse
X5 Wire Feeder 300 AP
X5 Wire Feeder 300 APC
X5 Wire Feeder HD300 AP
X5 Wire Feeder HD300 APC
X5 Power Source 400 Pulse
X5 Power Source 400 Pulse+
X5 Power Source 500 Pulse
X5 Power Source 500 Pulse+
X5 Power Source 400 MV Pulse+
X5 FastMig
1920960 / 2440