Ap/Apc Control Panel: Device Settings; Changing Settings - Kemppi X5 FastMig Operating Manual

3.3.8 AP/APC control panel: Device settings

Changing settings

1. Turn the right control knob to highlight the desired settings parameter.
2. Press the right control knob to select the settings parameter for adjustment.
3. Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4. Confirm the new value / selection and close the adjustment view by pressing the right control knob.
Users
The system settings can be customized for up to 10 different users. In addition to the system settings, the memory chan-
nels are user-specific. Each user can have up to 100 MIG channels, 10 TIG channels, 10 MMA channels and 10 gouging
channels. The memory channel and system settings are saved automatically for the logged-in user.
Settings
Parameter
User
Mode
© Kemppi
Parameter value
Current user
MIG/TIG/MMA/Gouging
114
Operating manual - EN
Description
There is always a logged-in user in the sys-
tem. When a new user logs in, the pre-
vious user is automatically logged out.
In case of a mixed double wire feeder
installation where the other wire feeder is
a Manual model, user 1 is automatically
applied and user change is disabled.
Note: For TIG welding the polarity (+/-)
must be switched. For more information,
refer to "Installing cables" on page 55.
X5 FastMig
1920960 / 2440