Kemppi X5 FastMig Operating Manual page 146

33 Welding cable
calibration fail-
ure
40 VRD error
42 High current in
wire feeder
motor
43 Overcurrent in
wire feeder
motor
Wire speed
44
measurement is
missing
License error
50
61 Operation not
allowed
Power source
62
not found
64 Robot control
device lost
65 Subfeeder not
allowed
81 Welding pro-
gram data miss-
ing
103 Empty memory
channel
132 Robot not
responding
Power source
238
serial number is
missing
Internal memory
244
failure
245 Demo time left:
%min min
Demo time has
246
expired
250 Internal memory
failure
© Kemppi
Welding cable calibration failed.
Open circuit voltage exceeds the VRD limit.
There may be too much pressure in the
wire feed rolls or dirt in the wire line.
There may be too much pressure in the
wire feed rolls or dirt in the wire line.
Faulty sensor or wiring in wire feeder.
License for the selected feature is missing.
Subfeeder is connected, but it has not been
selected in the system settings.
No power source is connected to the wire
feeder, or connection is faulty.
Wire feeder lost connection to the robot
control device.
Use of subfeeder is not allowed with selec-
ted welding process.
Welding program data has been lost.
Robot tried to start welding using a nonex-
istent memory channel.
There is a communication problem
between robot and the RCM.
Communication to serial number card
failed.
Initialization failed (%sub:%device).
When the demo time expires, the features
without a license cannot be used anymore.
Features without a license cannot be used
anymore.
Memory communication failed (%sub-
:%device).
Check the welding system cables and their con-
nections.
Restart the power source. If problem persists, contact
Kemppi service.
Adjust the feed roll pressure. Clean the wire line.
Change worn parts in the welding gun.
Adjust the feed roll pressure. Clean the wire line.
Change worn parts in the welding gun.
Restart the welding system. If problem persists, con-
tact Kemppi service.
To continue using the feature, please install the
license.
Go to the system settings menu on the control panel
and select your subfeeder model and type.
Check the control cable and its connectors.
Check the robot control device and interconnection
cables. If problem persists, contact Kemppi service.
Remove the subfeeder or change the welding pro-
cess.
Restart the power source. If problem persists, contact
Kemppi service.
Check the memory channel selected by the robot.
Check fieldbus cabling, connectors and the fieldbus
module.
Restart welding system. If problem persists, contact
Kemppi service.
Restart welding system. If problem persists, contact
Kemppi service.
To continue using the optional features, you must buy
licenses for them.
To continue using the optional features, you must buy
licenses for them.
Restart welding system. If problem persists, contact
Kemppi service.
146
X5 FastMig
Operating manual - EN
1920960 / 2440