Intermec EasyCoder PX4i User Manual page 124

Display Messages and LED Indications (continued)
Error/Event
LSS too low
Testfeed not done
Pause Mode entered
Setup Mode entered
IP link error
IP configuration error
Generic DP error
Press any key to continue Blink
Application load error
IRI blink by application Blink
IRI off by application
Application break
Printhead not found
Rebooted
Initializing
Printer crash
Printer turned off
Maintenance
Power supply Over
temperature
Printhead too hot
Note 1: This is only applicable for printers equipped with an EasyLAN interface.
Note 2: A printer that is equipped with an EasyLAN interface, but is not connected to a
network, will have a blinking IRI. To avoid this, the user can set "IP SELECTION" to
"MANUAL" and "IP ADDRESS" to "0.0.0.0". This will indicate that the user does not regard
the lack of network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Note 4: This error indicates that the printer has not received an IP address. It is only applicable
for printers with IP SELECTION set to DHCP and/or BOOTP.
EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
Ready-to-Work Error Number Comment
Blink 1008
Blink 1606
Blink
Blink
Blink
Blink
Blink
Blink
Off
Off
Off
Off
Off
Off
Off
Off
Off 1718
Off 1088
Chapter 10 — Troubleshooting
Including interactive setup
from Fingerprint/Direct
Protocol
See note 1, 2, and 3
See note 1, 3, and 4
See note 5
See note 6
See note 7
Set by Fingerprint instruction
SYSHEALTH
Set by Fingerprint instruction
SYSHEALTH
See note 8
Set at startup until operational
See note 3 and 9
Set when upgrading
See note 10
109