Intermec EasyCoder PX4i User Manual page 95

Chapter 7 — Setup Mode
SETUP:
PRINT DEFS
SETUP:
MEDIA
80 EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
The Setup Mode is organized as an endless loop, from which you
can select a number of sub-categories. with a number of sub-
categories. At startup, the firmware determines if options such as
label taken sensor or an interface board are installed in the
printer. Only installed options are shown in the Setup Mode.
The diagram below shows the options in the main loop. Detailed
overviews are shown on the following pages.
Starting point
SETUP:
SER-COM, UART1
SETUP:
FEEDADJ
SETUP:
SER-COM, UART2
SETUP:
NET-COM, NET1
SETUP:
NETWORK
Option
Option
SETUP:
SER-COM, UART3
Option
SETUP:
SER-COM, UART4
Option
SETUP:
SER-COM, UART5
Option
Option