Intermec EasyCoder PX4i User Manual page 184

Thermal Transfer Printing; 8 dots/mm (203.3 dpi) (continued)
Type/Speed Name
Duratran II Tag 64
TMX 3200 Duratran II
Gloss Polyester
1. Exceeding the recommended pring speed may cause the printhead to wear out prematurely. If
the ambient temperature is lower than =15°C (+59°F), decrease print speed by 50 mm/sec.
2. Applies to printing of text, lines, boxes, images, and picket fence bar codes.
3. Applies to ladder bar codes.
4. Requires high printhead pressure (See
Direct Thermal Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name
Top Coated Duratherm II
Duratherm II-2
Standard Duratherm II Tag
Top Coated Duratherm Lightning
High Duratherm Lightning Plus
Duratherm Lightning IR
Duratherm Lightning IR Tag 110
Thermal Transfer Printing; 11.81 dots/mm (300 dpi)
Type/Speed Name
TMX 1500 Duratran II
Label
Duratran II
Syntran
Duratran
Kimdura
Duratran S
EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
Ribbon Ribbon
Constant Factor
25
93 30
"Printhead Pressure" on page
Label
Constant
86
88
4
68
69
80
75
Ribbon Ribbon Label
Constant Factor Offset
53 25 0
64 25 0
64 25 0
63 25 0
Appendix D — Intermec Supplies
Label Max Rec. Print Speed
2
Offset Dir 1&3 Dir 2&4
0 200 200
0 150 150
131).
Label Max Rec.
2
Factor Dir 1&3
40 300
40 300
40 300
40 300
40 300
40 300
40 300
Max Rec. Print Speed
2
Dir 1&3 Dir 2&4
200 200
200 200
200 200
200 200
1
3
1
Print Speed
3
Dir 2&4
300
250
300
300
250
250
150
1
3
169