Cut-Off - Intermec EasyCoder PX4i User Manual

Cut-Off

EasyCoder PX4i Bar Code Label Printer User's Guide (Fingerprint Version)
The EasyCoder PX4i printer can print on labels, tickets, tags, and
continuous stock in various forms. This section describes the case
when the media is to be cut off by an automatic paper cutter
(option).
Press Feed when loading the same type of media as before. When
switching to a new type of media, or if the printer does not feed
out the media properly, simultaneously press Shift and Feed to
perform a "testfeed."
Cut-off can be used for:
• Non-adhesive continuous stock
• Self-adhesive labels with liner (cut only liner between labels)
The cutter is designed to cut through paper-based media with a
thickness between 60 and 175 μm, which roughly corresponds to
a paper weight of 60 to 175 grams/m
lb.). The cutter should not be used to cut through labels because
the adhesive will stick to the shears, which can damage the cutter.
The optional label taken sensor cannot be used with the cutter.
The rotating cutting blade can be accidently activated while the
cutter is open. To avoid any risk of injury to fingers, always switch
off the power before loading media and/or ribbon in a
cutter-equipped printer.
Chapter 4 — Loading Media
2
(basis weight 40 to 120
29