Skyleader 200 Pilot Operating Handbook page 40

40
2 333 371 B
2. Chose area for landing (check landing direction, landing surface, obstacles, wind speed / direction)
3. Make a 360° turn above the landing area in height of 100 - 200 ft AGL - check nature of landing area
4. Fuel cock – OPEN the fuel tank with greater fuel quantity
capacity, it is necessary to switch fuel cock to the left fuel tank)
5. Make an 'into the wind' low pass in takeoff configuration at a height of 100 - 200 ft AGL and an airspeed of
100-110 km/h on right side of landing area - check landing surface, estimate altitude of field (x ft) and 'runway'
heading
After low pass: Full throttle, Climb up, Make 1st and 2nd turn coupled
6. Flaps retract (at safe altitude), climb at 120km/h to altitude 500ft above field altitude (x + 500 ft)
7. Perform standard circle pattern
DOWNWIND
- Landing gear - OPEN -
20 sec.)
- Propeller - set MIN. angle (if it is adjustable)
- Engine and flight instruments - check values
- EMS-display - check for any error messages
- Fuel pump - "ON"
- Fuel pressure - check value
- Fuel gauges - check fuel amount
- Fuel cock – OPEN the fuel tank with greater fuel quantity
capacity, it is necessary to switch fuel cock to the left fuel tank)
- Seat belts - fasten and tighten
- Brakes – check function
- RWY, area of base leg and finals - clear for descent and landing
- Report (Downwind radio call)
- Plan the landing maneuvre
- Check landing area surface
BASELEG
- Airspeed 100-110 km/h
- Flaps - set takeoff position
KP 2U POH 05/2022
depends on landing area character (time for Landing Gear openning takes approx.
- max. speed 150 km/h
(if left-side fuel tank is filled more than 1/2 of fuel
(if left-side fuel tank is filled more than 1/2 of fuel