Disable Character - Datalogic PowerScan PD7100 Corded Product Reference Manual

RS-232/USB-Com Interfaces

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the the Dis-
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
feature.
Table 12. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
68
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
able Character is not used (not available).
on the inside back cover of this manual to find the hex equiv-
ASCII Chart
alent for the desired character/value.
ming Mode.
, that represent the desired character/value in step
E, Keypad
character will cause a two-beep indication.
ming Mode.
'd'
0x64
'6' and '4'
Data Bits
Table 12 for some examples of how to set this
EXAMPLES
'}' 'D'
0x7D 0x44
'7' and 'D' '4' and '4'
PowerScan
has been set as 7
Appendix
above. The second
1
Disable Command
Not Used
0xFF
'F' AND 'F'
®
PD7100 Corded