Standard 2 Of 5 Set Length 2 - Datalogic PowerScan PD7100 Corded Product Reference Manual

Symbologies
Standard 2 of 5 — cont.

Standard 2 of 5 Set Length 2

This feature specifies one of the barcode lengths for
Length 2 is the maximum label length if in
length if in
ters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore this
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
3. Scan the barcode: SELECT STANDARD 2 OF 5 LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
Table 34. Standard 2 of 5 Length 2 Setting Examples
STEP ACTION
Desired Setting (pad with leading
1
zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT STANDARD 2 OF 5 LENGTH 2 SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
256
Mode. Length includes the barcode's check and data charac-
Fixed Length
length). Pad the number with leading zeroes to yield two digits. For example: 0 =
00, 5 = 05, 20 = 20, etc.
ming Mode.
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
00 (Ignore This
Length)
'0' and '0'
Standard 2 of 5 Length Control
Variable Length
Appendix E, Keypad
for some examples of how to set this feature.
Table 34
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
PowerScan
Mode, or the second fixed
, that rep-
50 Characters
'5' AND '0'
®
PD7100 Corded
.