Datalogic 2 Of 5 Set Length 2 - Datalogic PowerScan PD7100 Corded Product Reference Manual

Datalogic 2 of 5 — cont.

Datalogic 2 of 5 Set Length 2

This feature specifies one of the barcode lengths for
Length 2 is the maximum label length if in
length if in
acters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50, or 0 to ignore this length).
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 =
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT Datalogic 2 of 5 LENGTH 2 SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
Table 28. Datalogic 2 of 5 Length 2 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to yield
2
two digits
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DATALOGIC 2 OF 5 LENGTH 2 SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. The length includes the barcode's check and data char-
Fixed Length
The length must be an even number.
05, 20 = 20, etc.
ming Mode.
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
Ignore This Length
00
'0' and '0'
Datalogic 2 of 5 Length Control
Variable Length
Appendix E, Keypad
for some examples of how to set this feature.
Table 28
EXAMPLES
4 Characters 14 Characters
04
'0' and '4' '1' and '4'
Datalogic 2 of 5
Mode, or the second fixed
, that rep-
50 Characters
14 50
'5' AND '0'
.
211