Nak Character - Datalogic PowerScan PD7100 Corded Product Reference Manual

RS-232/USB-Com Interfaces

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK charac-
ter. ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1. Determine the desired character or value.
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT NAK CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
ture.
Table 9. NAK Character Setting Examples
STEP ACTION
1 Desired Character/Value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK CHARACTER SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
60
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
on the inside back cover of this manual to find the hex equiv-
ASCII Chart
alent for the desired character/value.
ming Mode.
, that represent the desired character/value in step
E, Keypad
character will cause a two-beep indication.
ming Mode.
NAK
0x15
'1' and '5'
Data Bits
Table 9 for some examples of how to set this fea-
EXAMPLES
$ @
0x24 0x40
'2' and '4' '4' and '0'
PowerScan
has been set as 7
Appendix
above. The second
1
>
0x3E
'3' AND 'E'
®
PD7100 Corded