Label Id: Set Individually Per Symbology - Datalogic PowerScan PD7100 Corded Product Reference Manual

Label ID: Set Individually Per Symbology

To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable
3. Scan a barcode to select the symbology for which you wish to configure a custom
4. Determine the desired character(s) (you may choose up to three) which will repre-
5. Turn to the
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 6. Label ID Position Options
Product Reference Guide
as suffix) by scanning the appropriate barcode in the section
. Reference
page 105 Figure 6
fication features are enabled.
Label ID from the section
sent the Label ID for the selected symbology.
ASCII Chart
equivalent hex digits associated with your choice of Label ID. For example, if you
wish to select an equal sign (=) as a Label ID, the chart indicates its associated hex
characters as 3D. Turn to
representing the hex characters determined. For the example given, the characters
'3' and 'D' would be scanned. More examples of Label ID settings are provided in
.
Table 18
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Prefix Label ID Aim ID
for Label ID positioning options if multiple identi-
Label ID Symbology Selection, starting on page 106
on the inside back cover of this manual and find the
Keypad, starting on page 295
Bar Code Data Label ID
OR
Label ID Control on
and scan the barcodes
Suffix
Label ID
.
103