Enable Character - Datalogic PowerScan PD7100 Corded Product Reference Manual

RS-232/USB-Com Interfaces

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value.
Character is not used (not available).
1. Determine the desired character or value.
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
feature.
Table 13. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
70
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
on the inside back cover of this manual to find the hex equiv-
ASCII Chart
alent for the desired character/value.
ming Mode.
, that represent the desired character/value in step
E, Keypad
character will cause a two-beep indication.
ming Mode.
'e'
0x65
'6' and '5'
Data Bits
A setting of 0xFF indicates the the Enable
for some examples of how to set this
Table 13
EXAMPLES
'}' 'E'
0x7D 0x45
'7' and 'D' '4' and '5'
PowerScan
has been set as 7
Appendix
above. The second
2
Enable Command
Not Used
0xFF
'F' AND 'F'
®
PD7100 Corded