Code 128 Set Length 1 - Datalogic PowerScan PD7100 Corded Product Reference Manual

Code 128 — cont.

Code 128 Set Length 1

This feature specifies one of the barcode lengths for
1 is the minimum label length if in
Fixed Length
The length can be set from 1 to 80 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 80). Pad the number with lead-
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
3. Scan the barcode: SELECT CODE 128 LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
Table 23. Code 128 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 128 LENGTH 1 SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. Length includes the barcode's data characters only.
ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
ming Mode.
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
01 Character
'0' and '1'
Code 128 Length Control
Mode, or the first fixed length if in
Variable Length
Appendix E, Keypad
for some examples of how to set this feature.
Table 23
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Code 128
. Length
, that rep-
80 Characters
'8' AND '0'
185