Datalogic PowerScan PD7100 Corded Product Reference Manual page 105

5. If less than the expected string of 20 characters are selected, scan the ENTER/
6. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
7. The resulting message string would appear as follows:
This option sets up to 20 characters each from the set of ASCII characters or any hex val-
ue from 00 to FF. To configure this feature, scan the ENTER/EXIT barcode to place the
unit in Programming Mode, then the "Set Global Prefix" or "Set Global Suffix," barcode
followed by the digits (in hex) from the Alphanumeric characters in
representing your desired character(s). If less than the expected string of 20 charac-
pad
ters are selected, scan the ENTER/EXIT barcode to terminate the string. Reference the
section,
ming mode by scanning the ENTER/EXIT barcode once again.
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
Product Reference Guide
EXIT barcode to terminate the string.
Scanned barcode data:12345
Resulting message string output: $12345
Example: Setting a Prefix on page 96
ENTER/EXIT PROGRAMMING MODE
DEFAULT
, for more information. Exit program-
Set Global Prefix
No Global Prefix
Global Suffix = 0x0D (CR)
Global Prefix/Suffix
Appendix E, Key-
CANCEL
97