Datalogic 2 Of 5 Set Length 1; Datalogic 2 Of 5 Set Length 2 - Datalogic PowerScan PD96 Series Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Datalogic 2 of 5 Set Length 1

This feature specifies one of the bar code lengths for "
page 161
fixed length if in Fixed Length Mode. The length includes the bar code's check and data
characters. The length can be set from 2 to 50 characters in increments of two. See "
Length 1" on page 301
Select Datalogic 2 of 5 Length 1 Setting
$CD2L1
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Datalogic 2 of 5 Set Length 2

This feature specifies one of the bar code lengths for "
page 161
ond fixed length if in Fixed Length Mode. The length includes the bar code's check and
data characters. The length can be set from 2 to 50 characters. A setting of 00 specifies
to ignore this length (only one fixed length). See "
detailed programming instructions.
Select Datalogic 2 of 5 Set Length 2 Setting
$CD2L2
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
162
POWERSCAN™ PD/PM96XX
. Length 1 is the minimum label length if in Variable Length Mode, or the first
for more detailed programming instructions.

Length 1 = 06 (6 characters)
. Length 2 is the maximum label length if in Variable Length Mode, or the sec-

Length 2 = 50 (50 characters)
Datalogic 2 of 5 Length Control" on
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL
Datalogic 2 of 5 Length Control" on
Set Length 2" on page 302
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL
1D SYMBOLOGIES
Set
represent-
for more
represent-