cytiva NanoAssemblr Ignite Operating Instructions Manual page 85

Step
5
6
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA
Action
On the user interface, tap the heating control in the top right corner.
Result:
The Heater Control dialog appears on the screen.
Adjust the C and R sliders to the correct temperature.
Note:
To set the heaters to the same temperature, tap the check box next to Link.
Result:
The setpoint or setpoints chosen are shown in the top row of the heating
control indicator. The heating block immediately begins to heat the syringe
heaters. The actual temperature of each heater is displayed in the bottom
row of the heating control indicator.
6 Operation
6.3 Run a procedure
6.3.3 Optional: Preheat the system
85