Prerequisites And Required Materials - cytiva NanoAssemblr Ignite Operating Instructions Manual

6.3.2

Prerequisites and required materials

Prerequisites
The Ignite or Ignite+ must be installed by trained personnel. If syringe heating is used,
the heating block must be installed by authorized Cytiva personnel.
The correct size of sample arm must be installed prior to running a procedure. See
Section 5.4 Replace sample arm, on page 73
sample arm.
Required materials supplied by
Cytiva
Prior to starting a procedure, make sure you have the following available:
Material
Single use cartridge
Heating inserts (optional)
Required materials supplied by the
user
Prior to starting a procedure, make sure you have the following available:
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA

6.3.2 Prerequisites and required materials

for information about replacing the
Description
Ignite instrument: One of the following cartridges:
• Classic
• NxGen
• NxGen Dilution
Ignite+ instrument: One of the following cartridges:
• Classic
• NxGen
• NxGen Dilution
• NxGen 500
• NxGen 500D
If the procedure uses syringe heating: up to two
heating inserts; one heating insert for each channel
that uses heating. See
on page 38 for information about heating insert
compatibility.
6.3 Run a procedure
Section 3.5.1 Heating insert,
6 Operation
81