cytiva NanoAssemblr Ignite Operating Instructions Manual page 84

Step
3
4
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA
Action
Result:
Insert the heating insert or inserts into the appropriate channel of the
rotating block.
If using Ignite+ heating inserts, the three arrows on the insert must point in
the direction of the fluid flow.
Result:
The heating inserts snap into place magnetically.
Rotate the rotating block down into the default position.
6 Operation
6.3 Run a procedure
6.3.3 Optional: Preheat the system
84