Mec 1330SE Service & Parts Manual page 19

Section 10 - Maintenance
ART_6091
CAUTION
30-Day Service
Items on this checklist should be inspected before each work shift. Refer to the Operator's Manual.
The 30 day maintenance procedure is a one-time procedure to be performed after the first 30 days or
40 hours of usage.
Maintaining the tires and wheels in good condition is essential to safe operation and good
performance. Tire and/or wheel failure could result in a machine tip-over. Component damage may
also result if problems are not discovered and repaired in a timely fashion.
1. Check the tire surface and sidewalls for cuts, cracks, punctures and unusual wear.
2. Check each wheel for damage, bends and cracks.
3. Remove the wheel covers and check each center lock nut for proper torque and presence of
cotter pin.
Castle Nut Torque, Dry
Castle Nut Torque, Lubricated 125.4 ft-Ibs (170 Nm)
Page 15
Inspection and maintenance should be performed by qualified personnel
familiar with the equipment.
Front
166.7 ft-Ibs (226 Nm)
1330SE - Service & Parts Manual - 95834
Back
Locknut 100ft-Ibs (135 Nm)
October 2024