User Pi Control Mode (P1-12 = 3) - Invertek Drives Optidrive Plus 3GV User Manual

7.3. User PI control mode (P1‐12 = 3)
P2‐01 Digital input 1 (T2)
0..10,
Open: Stop (disable)
13..16,
Closed: Run (enable)
18
Open: Stop (disable)
11
Closed: Run (enable)
Open: Stop (disable)
12
Closed: Run (enable)
Open: Stop (disable)
17
Closed: Run (enable)
Open: Stop (disable)
19
Closed: Run (enable)
Open: Stop (disable)
20, 21
Closed: Run (enable)
Open: Stop (disable)
22
Closed: Run (enable)
When P3‐05 = 1, Bipolar analog input controls PID setpoint. The feedback must then be connected to Analog input 2 and P3‐10
NOTE must be set to 0 (Default setting)
The external trip input only functions when the feedback source is the Bipolar analog input (P3‐10 = 1)
For further information on configuring the PID controller for typical feedback applications, please refer to the Advanced User Guide.
24
www.invertek.co.uk
Digital input 2 (T3)
No Function
Open : PID control
Closed : Preset speed 1
Open : Preset speed 1
Closed : PID control
Open : PID Control
Closed : Bipolar analog ref
Open : PID Control
Closed : Analog input 2 ref
Digital Output :
Drive Healthy = +24V
Digital Output :
Drive Healthy = +24V
Digital input 3 / Analog input 2 (T4)
Analog input 2
External trip input
Open: Trip,
Closed: No Trip
External trip input
Open: Trip,
Closed: No Trip
Analog input 2
Analog input 2
Analog input 2
External trip input
Open: Trip,
Closed: No Trip
GV
Optidrive Plus 3 User Guide
Bipolar analog input (T6)
Bipolar analog input
Bipolar analog input
Bipolar analog input
Bipolar analog input
Bipolar analog input
Bipolar analog input
Bipolar analog input