Maintenance Schedule - probst SH-2500-UNI-B Operating Instructions Manual

Maintenance

Maintenance schedule

10.3
Probst specifies the following inspections and inspection intervals. The
Check or retighten all fastening screws after 25
operating hours. Check regularly every 50 operating hours:
2. Check the function of all joints, guides, bolts and gear wheels. Readjust
Maintenance activity
Check the condition of the load
securing chain and the suspension
hook.
Check safety devices:
• Pressure gauge
• Warning device
Check and clean the sealing lips of
the suction plates, replace if worn.
Clean all dust filters, replace if necessary.
Drain condensation water.
Check the tightness of the vacuum
circuit.
Check the condition of the hose
connections.
Check load-bearing
suspension, for deformation, wear or
other damage.
Check legibility of type and load
plate. Clean if necessary.
Check legibility of warning signs. Clean if
necessary.
Inspection sticker up to date?
Check the general condition of the
lifting device.
The operating instructions are available,
legible and accessible to personnel.
Check combustion engine.
Check the V-belt tension (> see section
Checking the V-belt tension).
Check vacuum pump.
• Check the wear of the carbon
sliders. Replace the carbon
sliders if necessary.
52400043
operator must comply with the legal regulations and safety
regulations applicable at the place of use. The intervals apply
for single-shift operation. In the event of heavy use, e.g. in multi-shift
operation, the intervals must be shortened accordingly.
1. Check all fastening screws and retighten to the valid tightening torque.
parts, e.g.
or replace if necessary.
Daily Weekly
X
X
X
X
X
See operating instructions for the combustion engine in
See operating instructions for the vacuum pump in the
appendix.
41 / 47
Monthly Half-
yearly
X
X
X
the appendix.
X
Annually
X
X
X
X
X
X
X
X
X
X
X
X
X
GB