Error Response References; Using The Command And Response Table; Entering Sis Commands: Helpful Tips - Extron electronics IPL EXP Series User Manual

Error Response References

The following superscripted numbers are used within the command descriptions on the following pages to identify
commands that may respond as shown:
= Commands that yield an E14 (not valid for this configuration) response if the current
14
= Commands that yield an E24 (privilege violation) response if you are not logged in at the
24
= Commands that may yield an E28 (file not found) response.
28

Using the Command and Response Table

The command and response table begins below. Symbols are used throughout the table to represent variables in
the command and response fields. Command and response examples are shown throughout the table. The ASCII
to HEX conversion table below is for use with the command and response table.
ASCII to Hex Conversion Table
Space
NOTE: For commands and examples of computer or device responses used in this guide, the character "
the number zero and "O" is the capital letter "o."

Entering SIS Commands: Helpful Tips

•
Upper and lower case characters may be used interchangeably in the command field unless otherwise
specified.
•
Commands may be sent back-to-back without spaces (for example,
• Numbers can be entered as 1, 2, or 3 digits.
configuration of the unit does not support that command.
administrator level.
IPL EXP Power Series • Modes of Operation, SIS Control and Configuration
•
2!65V1Z
).
0
" is
27