Installing The Mounting Fixture - Omron ZFX-C User Manual

Note
• The lens has a fixed focal point. The actual detection range and focal point vary from lens to lens, so adjust the
distance to the measurement target after replacing the lens or camera.
• The camera mounting distance listed in the following tables is an approximate value. Mount the Camera so that
the distance to the measurement target can be adjusted easily.
• If the object size and detection range are incompatible, use a combination of a camera (without lighting), standard
CCTV lens and light source.
Camera Only p.22

Installing the mounting fixture

The mounting fixture can be installed on all of the four mounting surfaces.
ZFX-SR10R/SR50R/SC10R/SC50R/SC90R (robot cable type)
Bracket
Except ZFX-SR10R/SR50R/SC10R/SC50R/SC90R (normal cable type)
Hooks
Grooves on camera
20
Mounting and Connecting Devices
1
2
Base
3
4
1
Mounting
fixture
2
Install the mounting fixture with the protrusion on its
base (black) aligned with the groove on the camera
body.
Install the mounting fixture on the camera body with
the bracket (silver) aligned with the base.
Tighten the base and the bracket with the provided
screws (M3 x 6).
⋅
Tightening torque: 0.54N
Fasten the base at the mounting position with screws.
Tightening torque
⋅
M4: 1.2 N m
⋅
1/4"-20UNC: 2.6 N m
Align the two hooks on one side of the mounting fix-
ture with the two grooves on the camera body.
Push the other hook down until it is snapped into
place.
Make sure that the mounting fixture is firmly fixed on the
camera.
m
ZFX-C User's Manual