Installing The Controller; Installation Precautions - Omron ZFX-C User Manual

Installing the Controller

Installation Precautions

To improve heat radiation, install the Controller only in the orientation show below.
Right
Do not install the Controller in the following orientations.
Wrong
Important
• Install the Controller so that the distance between the Controller and other devices is at least the dimensions shown
in the figure below to improve the ventilation.
When installing Controller only:
Min.
50 mm
• Keep the ambient temperature less than 50 °C. If the ambient temperature is higher than 50 °C, install a fan forced
cooling system or an air conditioner to keep the temperature lower than 50 °C.
• Avoid mounting on a panel, in which high-voltage emitting devices are installed to prevent ZFX-C operation from
being affected by noise.
• Allow at least 10 m between the Controller and power lines to keep noise at a low level in the operating environ-
ment.
ZFX-C User's Manual
Wrong
When installing the Controller With the Exhaust Unit
attached:
Min.
15 mm
Min.
50 mm
Mounting and Connecting Devices
Min. 15 mm
25