Omron ZFX-C User Manual page 20

Controller
Front
(4)
(1)
OMRON USB
OUTPUT RUN ERROR ENABLE
ZFX-C10
SD
CARD
ADJ
MENU RUN
(2)
AUTO ESC
SET
1 2 3 4
PULL OPEN
(9) (3)
Front
Name
(1) Indicator
(2) LCD monitor/touch panel
(3) Function keys
(4) Touch pen
(5) USB port
(6) SD card slot
(7) Mode switch
(8) Control keys
(9) Strap holder for touch pen
Note:
The judgment result is output to the OR signal via the parallel interface.
ZFX-C User's Manual
Operation
Top
panel cover
(1)
(5)
(6)
(7)
RGB
CAMERA2
(8)
Function
"Measuring" indicator (RUN): Lights in green when in the RUN mode.
Error indicator (ERROR): Lights in red when an error occurs.
Judgment indicator (OUTPUT): Lights in orange when the judgment result is
Trigger indicator (ENABLE): Lights in blue when the ZFX-C is ready for the
The LCD monitor displays setup menus and images captured from the cam-
eras. Various settings can be made on the touch panel by tapping menu but-
tons in the LCD monitor using the touch pen.
Specific functions are allocated to the Function keys.
The touch pen is used to operate the touch panel. This pen can be attached to
the Controller by tying its strap to the strap holder for the touch pen.
This port is for connecting to a personal computer via a USB cable.
This slot is for inserting the SD Card.
When the SD Card is inserted, the SD mark is displayed at the top right of the
screen.
Blue SD mark: The SD card is inserted but not being accessed.
Red SD mark: The SD card is being accessed.
This switch selects the operation mode.
MENU: Select this mode when setting measurement conditions.
ADJ: Select this mode when adjusting setting parameters as necessary refer-
encing the image and values displayed on the LCD monitor during con-
tinuous test measurement (measurement without measurement data
output to external devices).
RUN: Select this mode when performing measurement.
These keys are used to perform operations without the use of the touch pen.
This holder is for attaching the touch pen.
(2) (1)
ETHERNET
CAMERA1
(4)
OK or NG according to the setting. (Note)
measurement trigger input.
Bottom
(2) (3)
CONSOLE
RS-232C
PARALLEL1 PARALLEL0
(5)
ZFX-C
17