Operation Start/End Times - Omron CJ - 08-2008 Operation Manual

CJ1-H/CJ1M CPU Unit Ver. 2.0 Upgrades
Personal
computer
Mail
Mail
Program file (.OBJ) sent
as mail attachment.
CPU Unit Ver. 2.0 or Later
Summary
Note
Personal
computer
Mail
Mail
Program file created on CX-
Programmer (see note), file name
changed to REPLACE.OJB, and
file sent as mail attachment.
1-6-9

Operation Start/End Times

Previous CPU Units (Pre-Ver. 2.0 CPU Units)
CPU Unit Ver. 2.0 or Later
Local site (no Programming Device)
Internet
With CS/CJ-series CPU Unit Ver. 2.0, the user program can be automatically
transferred to the CPU Unit at power ON without a parameter file (.STD) if the
name of the program file (.OBJ) is changed to REPLACE.OBJ on the CX-Pro-
grammer and the file is stored on a Memory Card. If data files are included
with the program file using this function, the following data file names are
used: REPLACE.IOM, REPLCDM.IOM, REPLCE@.IOM.
1. If the Memory Card contains a REPLACE.OBJ file, any parameter file on
the Memory Card will not be transferred.
2. If the Memory Card contains both a REPLACE.OBJ file and a AUTOEX-
EC.OBJ file, neither will be transferred.
Remote site (no Programming Device)
Internet
Note With CX-Programmer Ver. 3.0 or higher, a program file (.OBJ) can be created
offline and saved on a computer storage media. Select Transfer - To File
from the PLC Menu. This enable creating a program file offline without a PLC
so that the name can be changed to enable sending the program file.
The time that operation started and the time operation ended were not stored
in the CPU Unit.
The times that operation started and ended are automatically stored in the
Auxiliary Area.
Program cannot be transferred
CPU Unit
(see note).
Program file
(AUTOEXEC.OBJ)
Note: Transfer is not possible because
there is no parameter file
(AUTOEXEC.STD).
Program can be transferred
CPU Unit
(see note).
REPLACE.OBJ
Note: Transfer is possible even
Section 1-6
without a parameter file
(AUTOEXEC.STD).
51