Omron CJ - 08-2008 Operation Manual page 149

Basic System Configuration
Cable
Using a XW2Z-
200S-CV/500S-CV
or XW2Z-200S-V/
500S-V cable for an
RS-232C connection
Note With a CS/CJ-series PLC, the connection must be a host link connection.
Connecting to the RS-232C Port
Cable
Using a XW2Z-
200S-CV/500S-CV
or XW2Z-200S-V/
500S-V cable for an
RS-232C connection
Note With a CS/CJ-series PLC, the connection must be a host link connection.
Programming Console
USB type A plug, male
CS1W-CIF31
D-sub Connector
(9-pin male)
D-sub Connector
(9-pin female)
XW2Z-200S-CV/500S-CV
or XW2Z-200S-V/500S-V
(See note.)
(9-pin female)
USB type A plug, male
CS1W-CIF31
D-sub Connector
(9-pin male)
D-sub Connector
(9-pin male)
D-sub Connector
(9-pin female)
Recommended cable:
XW2Z-200S-CV/500S-CV
or XW2Z-200S-V/500S-V
(See note.)
When using a Programming Console, connect the Programming Console to
the peripheral port of the CPU Unit and set pin 4 of the DIP switch on the front
panel of the Unit to OFF (automatically uses default communications parame-
ters for the peripheral port).
Connection Diagram
CS/CJ-series PLC connection
Customizable Counter Unit connection
D-sub Connector (9-pin male)
CS/CJ-series peripheral connector
D-sub Connector
CS1W-CN118
Connection Diagram
CS/CJ-series PLC connection
Section 2-3
Peripheral port
RS-232C port
D-sub Connector
(9-pin female)
101