Omron CJ - 08-2008 Operation Manual page 357

PLC Setup
Baud Rate (bps)
Programming
Console address
Word Bit(s)
+145 0 to 7 00: Standard
0A: High-speed NT
Link*
Default: 00
NT Link Max. (Maximum Unit Number in NT Link Mode
Programming
Console address
Word Bit(s)
+150 0 to 3 0 to 7
Default: 0
Peripheral Bus Settings
Communications Setting
Programming
Console address
Word Bit(s)
+144 15 0: Default (stan-
dard)*
1: PLC Setup (cus-
tom)
Default: 0
Mode: Communications Mode
Programming
Console address
Word Bit(s)
+144 8 to 11 4: Peripheral bus
Default: 0
Baud Rate (bps)
Programming
Console address
Word Bit(s)
+145 0 to 7 00: 9,600 bps
06: 9,600 bps
07: 19,200 bps
08: 38,400 bps
09: 57,600 bps
0A: 115,200 bps
Default: 00
Settings
* Set to 115,200 bps when setting this value
from the CX-Programmer.
Settings
This setting determines the highest unit
number of PT that can be connected to the
PLC in NT Link mode.
Settings
*The default settings are for a baud rate of
9,600 bps.
Settings
This setting determines whether the com-
munications mode for the peripheral port.
The Peripheral Bus Mode is used for all Pro-
gramming Devices except for Programming
Consoles.
Settings
The following settings are valid for the
Peripheral Bus Mode: 00 and 06 to 0A hex.
Function
)
Function
Function
Function
Function
Section 7-1
Related When set-
flags and ting is read
words by CPU Unit
A61901 At the next
(Peripheral cycle.
Port Settings (Also can be
Changing changed with
Flag) STUP (237).)
Related When set-
flags and ting is read
words by CPU Unit
A61901 At the next
(Peripheral cycle.
Port Settings (Also can be
Changing changed with
Flag) STUP (237).)
Related When set-
flags and ting is read
words by CPU Unit
A61901 At the next
(Peripheral cycle.
Port Settings (Also can be
Changing changed with
Flag) STUP (237).)
Related When set-
flags and ting is read
words by CPU Unit
A61901 At the next
(Peripheral cycle.
Port Settings (Also can be
Changing changed with
Flag) STUP (237).)
Related When set-
flags and ting is read
words by CPU Unit
A61901 At the next
(Peripheral cycle.
Port Settings (Also can be
Changing changed with
Flag) STUP (237).)
309