Power Supply Units; Power Supply Units Models - Omron CJ - 08-2008 Operation Manual

Power Supply Units

Communications Mode Selection Flowchart
Connecting Device (Protocol)
CX-Programmer
Host computer
OMRON PT
General-purpose external serial device
OMRON component (CompoWay/F)
RS-232C Port Communications Settings
1. Peripheral bus
(auto-detect)
2. Peripheral bus
3. Host Link
4. NT Link
5. No-protocol
6. Serial Gateway
3-4

Power Supply Units

3-4-1

Power Supply Units Models

Power supply voltage
100 to 240 V AC
(allowable: 85 to 264 V AC)
50/60 Hz
(allowable: 47 to 63 Hz)
170
Peripheral bus connection
Host Link connection
Connection
Pin 5 of Front-panel
ON
OFF (factory setting) Peripheral bus
OFF (factory setting) Host Link (default setting)
OFF (factory setting) NT Link
OFF (factory setting) No-protocol
OFF (factory setting) Serial Gateway
Note Set from the CX-Programmer or Programming Console.
Output Power
output
terminals
5 A at 5 V DC No
0.8 A at 24 V DC
Total: 25 W
5 V DC, 5.0 A No
24 V DC, 0.8 A
Total 25 W
2.8 A at 5 V DC No
0.4 A at 24 V DC
Total: 14 W
Communicate with the
CX-Programmer's communications
settings (peripheral bus).
Communicate with the PLC Setup's
communications settings
(peripheral bus).
Communications Settings
PLC Setup RS-232C port
DIP Switch setting (See note.)
---
RUN Replacement
output notification
function
Yes Without
No Display: Sup-
ported
Output: Sup-
ported
No Without
Section 3-4
Communications Mode
1. Peripheral bus (auto-detect)
2. Peripheral bus
3. Host Link
4. NT Link
5. No-protocol
6. Serial Gateway
Model Weight
CJ1W-PA205R 350 g max.
CJ1W-PA205C 400 g max.
CJ1W-PA202 200 g max.