Omron CJ - 08-2008 Operation Manual page 443

Auxiliary Area
Debugging Information
■ Online Editing
Name
Online Editing Wait Flag
Online Editing Processing
Flag
Online Editing Disable Bit
Validator
Online Editing Disable Bit
■ Output Control
Name
Output OFF Bit
■
Differentiate Monitor
Name
Differentiate Monitor
Completed Flag
■ Data Tracing
Name
Sampling Start Bit
Trace Start Bit
Trace Busy Flag
Trace Completed Flag
Trace Trigger Monitor Flag
File Memory Information
Name
Memory Card Type
Memory Card Format Error
Flag
File Transfer Error Flag
File Write Error Flag
File Read Error
Address
A20110 ON when an online editing process is waiting.
(An online editing request was received while online editing
was disabled.)
A20111 ON when an online editing process is being executed.
A52700 to The Online Editing Disable Bit (A52709) is valid only when
A52707 this byte contains 5A.
A52709 Turn this bit ON to disable online editing.
Address
A50015 Turn this bit ON to turn OFF all outputs from Basic I/O Units,
Output Units, and Special I/O Units.
Address
A50809 ON when the differentiate monitor condition has been estab-
lished during execution of differentiation monitoring.
Address
A50815 When a data trace is started by turning this bit from OFF to
ON from a Programming Device, the PLC will begin storing
data in Trace Memory by one of the three following methods:
1) Periodic sampling (10 to 2,550 ms)
2) Sampling at execution of TRSM(045)
3) Sampling at the end of every cycle.
A50814 Turn this bit from OFF to ON to establish the trigger condi-
tion. The offset indicated by the delay value (positive or neg-
ative) determines which data samples are valid.
A50813 ON when the Sampling Start Bit (A50815) is turned from
OFF to ON. OFF when the trace is completed.
A50812 ON when sampling of a region of trace memory has been
completed during execution of a Trace. OFF when the next
time the Sampling Start Bit (A50815) is turned from OFF to
ON.
A50811 ON when a trigger condition is established by the Trace Start
Bit (A50814). OFF when the next Data Trace is started by
the Sampling Start bit (A50815).
Address
A34300 to Indicates the type of Memory Card, if any, installed.
A34302
A34307 ON when the Memory Card is not formatted or a formatting
error has occurred.
A34308 ON when an error occurred while writing data to file memory. Read-only
A34309 ON when data cannot be written to file memory because it is
write-protected or the data exceeds the capacity of the file
memory.
A34310 ON when a file could not be read because of a malfunction
(file is damaged or data is corrupted).
Description
Description
Description
Description
Description
Section 9-11
Access
Read-only
Read-only
Read/write
Read/write
Access
Read/write
Access
Read/write
Access
Read/write
Read/write
Read/write
Read/write
Read/write
Access
Read-only
Read-only
Read-only
Read-only
395