Control Block - HP 3563A Operating Manual

Control Block

This group of keys helps control the analyzer's operation.
START:
used to start a measurement.
PAUSE/CONT: used to pause or continue a measurement.
AUTO SEa: used to set up and control auto sequence programs.
SAVE/RECALL: used to save and recall analyzer state or data - there are five non-volatile
storage locations for each, numbered 1 through 5. You can also recall the state at last power
shutdown.
SPCL FCTNS:
accesses a number of the analyzer's miscellaneous features, such as:
•
Time and date settings
•
Beeper control
•
Visual help features
•
Self-tests and service tests
PRESET: presets the analyzer to the current measurement mode and displays the special
preset menu. To perform a complete reset to power-on conditions, press the RESET softkey.
CCNTROL
-
leQNT
START c
FeTN
RECALL
Figure 1-9. Control Block
( ft)
on/o
0
PRESET
Introduction
Front-Panel Tour
1 -1 3