Using The Analog Source - HP 3563A Operating Manual

Using The Linear Resolution Mode
Setting up the Source: Linear Resolution Mode

Using the Analog Source

To select analog output [or the source, press
highlighted and underlined. In this case, the following soft keys appear:
Note When the source is analog, the source output is the front-panel BNC labeled
SOURCE.
SOURCE
AN DIG
SOURCE
LEVEL
SOURCE
TYPE
DC
OFFSET
SOURCE
OFF
3-1 0
SOURCE
Configures the source output to be analog (using the front panel BNC)
or digital (using pods on the rear panel.) Default
current selection is underlined and highlighted. When Channel 1 is set
to digital with input from the source (as specified with the
hardkey - see chapter 7, "Input Setup" for details), the
CON FIG
source is automatically set to digital.
Al l ows you to set the amplitude level of the source. When the source is
analog, you use the Entry group to set the analog-source level between
OV and +5.1V. There are 1,024 5 mV steps. The maximum current is
20 mA Note that the combined ac plus dc level
The default level is 0 V.
tYP
Pulls up the source- es menu_ See "Selecting a Source Type."
Allows you to add a positive or negative offset to the source output
signal. The offset limited to 10V minus the source level; the
is
combined ac and dc level is limited to ± 10V. The default dc offset is 0
volts.
Turns the source output off. If source protection is on, the source
ramps off gradually. See "Source Protection".
and toggle SOURCE AN DIG
i �
analog data. The
is
limited to ± 1 0 V.
.
so that AN is
IN PUT