Selecting Linear Or Log Sweep - HP 3563A Operating Manual

Sel ecting Linear or Log Sweep
The choice between LINEAR SWEEP
started (any time you press the yellow
measured or synthesized with linear resolution then converted to a log scale using the
coordinates, points in the resultant trace will not be distributed proportionally. To achieve true log
distribution, the original trace must have log resolution. The reverse is true for converting log traces
to linear scale using the
more information on the
values are converted to linear or log values (i.e., Hertz or octaves/ decades) when the sweep type is
changed.
and LOG SWEEP
START key the sweep starts again). If a trace is originally
LlN X coordinate. See "Selecting Display Coordinates" in chapter
LOG X and LlN X coordinates. Note that the sweep rate and resolution
uSing I ne \:>wepl �Ine Iv!ooe

Selecting Linear or Log Sweep

must be made before the measurement is
LOG X
8
for
5-23